Bissell powerforce powerbrush pet not spraying water

Document

If you are experiencing Low/No Spray, follow these steps to resolve:

• Is the Brush Roll Turning? 
  • No > Go to Brush Not Turning
  • Yes > If available on your model, make sure the cleaning mode is clearly selected 
• In Express mode much less water is applied, switch to DeepClean mode for more water/formula

• Remove clean water tank and check that the tank is not warped, damaged, or cracked
  • If clean water tank is damaged, warped, or cracked, a new one should be ordered > Go to Parts & Supplies

• Over a sink, push up on valve on bottom of clean tank
  • Does water come through? 
    • Yes > Reinsert tank and firmly push it back into place leaving no gaps
      • If there are gaps, or tank does not seat properly, order a new clean water tank > Go to Parts & Supplies 
    • No > A new clean water tank should be ordered > Go to Parts & Supplies

• Has this resolved the issue? 
  • Yes > Great! Glad we could get you back to cleaning! 
  • No > Where is there No Spray?
    • Hose > Go to No Spray to Hose
    • Foot > Go to Handle Removal

Was this answer helpful?

Document

If you are experiencing No/Low Spray, follow these steps to resolve:

Make sure trigger is pressed down when performing wet passes 

• Turn off and unplug machine
• Remove clean water tank lifting up on handle, set aside

• Turn upper cord wrap over and remove power cord, set aside
• Remove upper handle
  • Press black button below upper power cord wrap and pull up on handle

• Remove middle handle
  • Press black button below lower power cord wrap and pull up

• Slide middle handle back onto lower body of machine until it clicks

• Slide upper handle into middle handle until it clicks

• With machine unplugged and turned off pull trigger
  • Is there pressure in the trigger? 
    • Yes > Fill clean water tank 
    • No > Order new middle & upper handle > Go to Parts & Supplies 
• Inspect clean water tank and cap for cracks, damage, or deformation
  • If damaged or deformed, replace clean water tank or cap >  Go to Parts & Supplies 
  • If cap is missing red gasket, replace cap > Go to Parts & Supplies 

• Reseat clean water tank on machine until it clicks
  • If tank does not click into place, order a new clean water tank > Go to Parts & Supplies 

• Plug machine in and turn on
• Check for spray by pressing down on the trigger and performing a few wet and dry cleaning strokes
  • Has this resolved your issue? 
    • Yes  > Great! Glad we can get you back to cleaning!
    • No  > Contact Us

Was this answer helpful?