2006 toyota tacoma 2.7 crankshaft position sensor location

Estimate price near me

Included for free with this service

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

How much does a Crankshaft Position Sensor Replacement cost?

On average, the cost for a Toyota Tacoma Crankshaft Position Sensor Replacement is $192 with $97 for parts and $95 for labor. Prices may vary depending on your location.

Show example Toyota Tacoma Crankshaft Position Sensor Replacement prices

What is the Crankshaft Position Sensor all about?

Many newer cars have computerized engine management systems that rely on sensors to report data to the computer. The crankshaft position sensor is used in conjunction with the camshaft position sensor to control ignition timing and to let the computer know when to inject fuel and provide spark sequence. Due to the mounting locations of this sensor, it is common for heat and oil leaks to cause this sensor to fail.

Keep in mind:

• Damage to the crankshaft position sensor is sometimes caused by leaking oil, which means there may be another component of your vehicle that needs replacement or repair.
• The electrical connector can also be damaged, and should be inspected every time the position sensor is replaced.

How it's done:

• Scan the car for trouble codes.
• Remove and replace crankshaft position sensor.
• Clear trouble codes.
• Check for the proper operation of the car.

Our recommendation:

The crankshaft position sensor will usually let you know when it needs replacing. The Check Engine warning light will illuminate and you may notice that your vehicle has a hard time starting or running smoothly. When you notice any of these signs, schedule an inspection.

What common symptoms indicate you may need to replace the Crankshaft Position Sensor?

• Car does not start.
• Check engine light is on.
• Car misfires (car runs rough).

How important is this service?

The crankshaft position sensor relays critical information to your vehicle’s computer management system. The sensor provides the management system with the information it needs to control ignition timing, and it lets the computer know when it needs to provide sparks and fuel. Without a functioning crankshaft position sensor, the computerized management system doesn’t receive this critical information, and the vehicle will either not start, or will misfire while you’re driving it.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Recent articles & questions

What causes sensors to be damaged or get dirty?

Modern vehicles are equipped with dozens of different sensors. Sensors (https://www.yourmechanic.com/article/how-your-ecu-uses-sensor-data) are small electrical components, typically housed in plastic, that provide readings to different computers in a vehicle. While their role is big, the sensors themselves and the wires that...

after 20 mins of driving my car acts likes its suffercating until it cools down

A faulty air/fuel oxygen sensor (https://www.yourmechanic.com/services/oxygen-sensor-replacement) may cause the engine to run rough as it send improper information to the vehicles computer. I'm curious if the Check Engine Light is on. If there is a faulty sensor the vehicle can...

My hot temperature light is blinking and the temperature is below the C mark. Is it safe to drive home?

Hi there. The coolant temperature sending unit is malfunctioning and sending the vehicle the wrong information or the gauge on the dash has failed. The sending unit could have burned inside causing the computer to think that the engine is...

1. Home
2. Estimates
3. Toyota
4. Tacoma
5. Crankshaft Position Sensor Replacement

What are the symptoms of a failing crank sensor?

Where is crankshaft sensor located?