Show
2015 Toyota Corlla The 2015 Toyota Corolla is equipped with the Toyota Maintenance Data System. After performing the oil change, the oil change indicator will need to be reset. The reset can be performed by following these instructions:1. Press the "ENGINE START STOP" switch once (do not start engine) or turn ignition key to run (one position before starting engine).2. Ensure Trip Metre A reading is shown (use the Trip button for vehicles with a Multi-Information display or DISP for vehicles with a drive monitor display). Turn the ignition off.3. While pressing the Trip Meter reset button (Multi-Information Display) or while pressing the DISP button (for vehicles with a drive monitor display), press the "ENGINE START STOP" switch once (do not start engine) or turn the key in the ignition to run (one position before starting engine).4. Continue to press and hold the button until the trip meter displays "000000".5 Turn the ignition off and then start the engine to verify the indicator has been reset.Use the DISP button for vehicles not equipped with the Multi-Information DisplayNon Multi-Information DisplayWhen doing the oil change and topping up fluids you will need to use the following specifications:Use the Trip button for vehicles equipped with the Multi-Information DisplayMulti-Information Display
You can cross reference the following Purolator filter numbers for your own application:4 Cyl. 1.8L
Always consult the owner’s manual or manufacturer prior to any service.*At the time of this posting being publishedhttps://www.oilreset.comComments are closed. What is maintenance required 2015 Toyota Corolla?The Toyota maintenance light can appear on your dashboard as “MAINT REQD”. It's a light that remains active permanently, letting you know that you need to go for an oil change in a certified auto shop. Changing the oil in your Toyota can improve fuel efficiency and make your vehicle run as smooth as silk.
How do I clear the maint light on 2015 Toyota Camry?Quickly push and hold the odometer button on your dashboard, then turn your key to position two. Continue to hold the odometer button for about 10 seconds. The maintenance light should start to flash, and you may hear a beeping sound. Then the light should go out.
How do I clear my maintenance required light?How do I reset the "Maint Reqd" light?. Turn ignition switch to the ON position.. Set the Odometer/Trip Display to TRIP A mode.. Turn the ignition switch to the OFF position.. Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.. The Service Maintenance Reminder Light will.. |