How to install ring doorbell battery powered

There are lots of video doorbells that need to be hardwired, which means you will need to replace an existing doorbell to power them. However, Ring has a battery-powered doorbell that can be installed anywhere. Here’s how to install a Ring doorbell without an existing doorbell, and how to charge your doorbell.

Table of Contents Show

How to Charge a Ring Doorbell
How to Install a Ring Doorbell without an Existing Doorbell
Can you install Ring Doorbell without wiring?
Which Ring Doorbell does not require wiring?
Can you wire a battery Ring Doorbell?

Without wiring, your Ring doorbell will not have a power source. Therefore, the first thing that Ring recommends you need to do is fully charge the battery.

How to Charge a Ring Doorbell

Remove the battery from the bottom of the Ring doorbell.
Plug the Ring doorbell battery to a power source using the orange USB cable. The battery will be fully charged if the light on top turns green, and there is no orange light.
Insert the battery back into the Ring device.

The battery should last at least 6 months, depending on how often the doorbell is used. To avoid downtime, you can purchase a 2nd battery to keep as a replacement.

How to Install a Ring Doorbell without an Existing Doorbell

Now that you know how to charge your Ring doorbell’s battery, you can proceed to installing the doorbell. Follow the steps below:

Insert the level tool into the front of your Ring device. You will need to do this before you add the faceplate. The level tool is included in the Install Tools box. It is a small orange bar with some fluid inside.
Using the level tool, position the Ring Doorbell where you want it installed. You want the device to be around 4 feet off the ground (at chest height). The bubble in the level tool should be dead center.
Mark off the mounting holes using a pencil. This step is only necessary if you are installing your Ring video doorbell on stucco, brick, or concrete. For this kind of installation, you will need to use the provided bit to drill a hole into your wall. Then insert the provided anchors into the holes.
Screw your Ring doorbell into the wall.
Place the faceplate on the Ring video doorbell. Insert the top of the faceplate at an angle and slot it into place until it clicks. Make sure that you remove the level tool first.
Tighten the security screws by the bottom of the doorbell. Use the screwdriver and star-shaped security screw provided to tighten the faceplate into place.

Note: Before you install your doorbell, make sure that you download the app and set up your Ring doorbell account first.

Now that you know how to install a Ring video doorbell without an existing doorbell, check out our guide on how to boost your WiFi signal, so it can reach your device.

Ring Video Doorbell 3

$199.00

$199.99

in stock

BUY NOW

HelloTech.com

Ring Video Doorbell 3 – enhanced wifi, improved motion detection, easy installation

$139.99

$199.99

in stock

2 used from $104.99

as of December 19, 2022 3:22 pm

BUY NOW

Amazon.com

Last updated on December 19, 2022 3:22 pm

HelloTech editors choose the products and services we write about. When you buy through our links, we may earn a commission.

Can you install Ring Doorbell without wiring?

Which Ring Doorbell does not require wiring?

Most models of the Ring Doorbell (except the Ring Doorbell Pro) don't need to be hardwired. What is this? You can have it run off its battery entirely. Since it uses Wi-Fi to connect to a Chime, you can simply mount it and connect it to the Chime.

Can you wire a battery Ring Doorbell?

If you hardwire your battery-powered Ring Video Doorbell, it does not actually use the wired power to run its operations. It relies on the battery for that. The trickle charge the Video Doorbell gets from being hardwired is solely used to charge the battery.

install ring doorbell battery powered