2006 jeep liberty turn signal bulb replacement

Comments: 0
Favorites: 0
Completions: 1

Table of Contents Show

Introduction
0 Comments
Is the tail light and turn signal the same bulb?
Can I change my own turn signal bulb?
Why is my turn signal bulb on but not blinking?

Back2002-2007 Jeep Liberty
Full Screen
Options

History
Download PDF
Edit
Translate
Embed This Guide

Introduction

The rear indicator light of a vehicle communicates the driver’s intention to turn or change lanes. However, indicator light bulbs go out after years of use. Driving with a broken indicator light bulb is dangerous and often illegal. This guide will help you replace the rear indicator light bulb of a 2002-2007 Jeep Liberty.

Tools

Parts

Open the vehicle's rear door to access the tail light assembly.

Use the T-20 Torx screwdriver to unscrew the two screws holding the tail light cover.

Remove cover by pulling out and away from car.
The cover is fastened with two plastic alignment pins.

Twist the middle socket counter-clockwise.
Pull the socket out of the tail light assembly to access bulb.

Grasp the lightbulb and pull it out of the socket.

Almost done!

To reassemble your device, follow these instructions in reverse order.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Madison Brown

Member since: 03/30/2020

145 Reputation

1 Guide authored

Team

0 Comments

Is the tail light and turn signal the same bulb?

In many newer cars there is one light bulb per tail light. There are two filaments in each light bulb. One is for your brake light and one is for your turn signal.

Can I change my own turn signal bulb?

If you have just one turn signal that is out, then you can likely repair that issue for a very small expense and a few moments of your time. Changing out a turn signal bulb is quick and easy. It simply involves removing the burnt light bulb and replacing it with a new one.

Why is my turn signal bulb on but not blinking?

If the lights are working fine but are not flashing, this is an issue with the turn signal flasher or turn signal switch. If you want to check this problem out yourself, you will need to access the signal switch electrical connector.

jeep liberty turn signal bulb replacement